Infiltração e redistribuição da água em solos irrigados por gotejamento: caracterização do avanço da frente de molhamento
Data
2019-07-26
Autores
Título da Revista
ISSN da Revista
Título de Volume
Editor
Resumo
Water efficiency makes dripping the most expansive irrigation system in modern world agriculture.
One of the observable characteristics in drip irrigated soil is the wetness front. The use of
mathematical models to estimate the dimensions of this front is important for the design of drip
systems, using the saturated hydraulic conductivity (KS) of the soil as a parameter of adjustment and
calibration. The Beerkan semiphysical method determines the hydrodynamic properties of the soil,
among them, KS. Thus, this work aimed to investigate the relationship between the advance of the
soil wetness front in a drip irrigation system and with a semi-physical method. The experiment was
carried out at UFRPE/UAST, irrigating two soils (FAr and FAAr), through three driping irrigation
systems, with three different flow rates (2.8, 4.4 and 8.3 L h-1) for ten intervals of time (5, 10, 15,
20, 30, 40, 50, 70, 90, 110 min.). The measured dimensions were diameter (d) and depth (p), given
in centimeters (cm). Soils FAr and FAAr obtained similar values for the observed dimensions (d and
p). The best time irrigation responses for the Soil FAr were found for the 8.3 L h-1 flow for 30 min
of irrigation for (d), and 8.3 L h-1 for 50 min for (p). In the FAAR soil, the best responses were flow
8.3 L h-1 for 50 min and flow 8.3 L h-1 for 70 min for (d) and (p), respectively. It was possible to
estimate the geometrical dimensions of the wetness front, diameter and depth from the Ks obtained
from the Beerkan methodology. The estimated dimensions from Ks obtained a positive correlation
with the observed dimensions, with R2 > 0.90 for all correlations. The adjusted equations can be
used to estimate the area and volume of wet soils for all flows at any time interval.
Descrição
A eficiência da aplicação da água torna o gotejamento como o sistema de irrigação de maior caráter
expansivo da agricultura mundial moderna. Umas das características observáveis em um solo
irrigado por gotejo é a frente de molhamento. A utilização de modelos matemáticos para estimar as
dimensões dessa frente é importante para o projeto de sistemas de gotejamento, utilizando a
condutividade hidráulica saturada (KS) do solo como parâmetro de ajuste e calibração. O método
semifísico Beerkan determina as propriedades hidrodinâmicas do solo, dentre elas, KS. Assim, o
objetivo do trabalho foi investigar a relação entre o avanço da frente de molhamento do solo em um
sistema de irrigação por gotejamento e com um método semifísico. O experimento foi realizado na
UFRPE/UAST, irrigando dois solos (FAr e FAAr), através de três sistemas de irrigação por
gotejamento, com três vazões diferentes (2,8, 4,4 e 8,3 L h-1), analisadas durante dez intervalos de
tempo (5, 10, 15, 20, 30, 40, 50, 70, 90, 110 mim). As dimensões aferidas foram o diâmetro (d) e a
profundidade (p), dadas em centímetros (cm). Os Solos FAr e FAAr obtiveram valores próximos,
para as dimensões observadas d e p. As melhores respostas a irrigação no tempo, para o Solo FAr
foram encontradas para a vazão 8,3 L h-1, por 30 min. de irrigação para (d) e 8,3 L h-1, por 50 min.
para (p). No Solo FAAr, as melhores respostas foram vazão 8,3 L h-1, por 50 min e vazão 8,3 L h-1,
por 70 min, para (d) e (p), respectivamente. Foi possível estimar as dimensões geométricas da frente
de molhamento, diâmetro e profundidade, a partir da Ks obtida a partir da metodologia Beerkan. As
dimensões estimadas a partir de Ks obtiveram uma correlação positiva com as dimensões
observadas, com R2 > 0,90 para todas as correlações. As equações ajustadas podem ser utilizadas
para estimar a área e volume de solos molhados para todas as vazões em qualquer intervalo de
tempo.
Palavras-chave
Irrigação, Solos irrigados, Irrigação por gotejamento
Referência
AMARAL, Erison Martins. Infiltração e redistribuição da água em solos irrigados por gotejamento: caracterização do avanço da frente de molhamento. 2019. 46 f.Trabalho de Conclusão de Curso (Bacharelado em Agronomia) – Unidade Acadêmica de Serra Talhada, Universidade Federal Rural de Pernambuco, Serra Talhada, 2019.